What dihedral does
Dihedral is the upward angle of each wing panel from horizontal. It adds roll stability: if one wing dips, the airflow tends to lift it back. That makes a plane easier to keep level.
Dihedral limits roll drift, but it does not make a plane fly level on its own or hold a perfect heading.
Typical values by plane type
These are rough values per side. Designs vary.
| Plane type | Approximate dihedral per side |
|---|---|
| Aerobatic and 3D | 0 to 1° |
| Low-wing sport | 1 to 3° |
| High-wing trainer | 3 to 5° |
| Rudder-elevator models without ailerons | Often polyhedral, with tips of 5 to 10° or more per break |
High-wing placement adds roll stability on its own, so high-wing models need less dihedral than low-wing models.
Plans give tip rise or an angle
Many plans give dihedral as the height of each wing tip above the board, not as an angle. Some plans give a total angle for both wings, and others give a per-side angle. Check which one your plan means, because misreading it can double or halve the dihedral.
To convert a tip rise to an angle:
tip rise = semi-span × tan(angle)
For example, a wing with a 30-inch semi-span set at 3° has a tip rise of about 1.57 inches, because 30 × tan 3° ≈ 1.57.
Set the dihedral on the board
Lay one panel flat on the board. Then either block up the other tip to the total rise, or block each tip to its own rise. Use whichever method the plan intends, and confirm it before you glue.
The dihedral brace
Join the wing halves with a dihedral brace, usually cut from 1/8-inch birch plywood to the plan’s angle. Epoxy it across the spars with 30-minute epoxy. On many built-up wings, the center joint is also wrapped with fiberglass tape for strength.
Sweep and high wings change the picture
Swept wings add some effective dihedral, so a swept wing may need less built-in dihedral. A high-mounted swept wing adds stability too. Some jet and scale models use a small anhedral, which is a downward angle, to offset that extra stability.
Polyhedral and rudder-elevator gliders
Rudder-elevator gliders with no ailerons depend more on dihedral, and they often use a polyhedral wing with steep tips. For glider designs, see RC glider and flying wing plans.
Too much versus too little
- Too much dihedral can cause Dutch roll, a combined wallowing and yawing motion. It also makes knife-edge flight poor and reduces aileron effectiveness.
- Too little dihedral means the plane won’t self-level well and may enter a spiral dive if you let go of the sticks.
Common mistakes
- “High-wing stability comes from a pendulum effect.” Most of it comes from aerodynamic sidewash and body effects, not hanging weight.
- “Dihedral makes a plane fly level on its own.” It limits roll drift but doesn’t hold a perfect heading.
- “Total and per-side angles mean the same thing.” Plans differ, so check which one you have.
- “More dihedral is always safer.” Excess dihedral causes Dutch roll and makes the ailerons less effective.
Safety
Use 30-minute epoxy in a ventilated space for wing joints. Wear gloves, because repeated skin contact with epoxy can cause sensitization.