Why flaps are deployed for landing
Flaps increase the wing’s camber, and some types also add wing area. That gives more lift at a lower speed, so the plane can fly a slower approach and land in a shorter distance. Flaps also add drag, which helps you lose height.
Flaps are not only for landing. A small setting can shorten a takeoff too.
Flap types
- Plain flaps are the most common on RC models. The trailing edge hinges down.
- Split flaps hinge from the underside of the wing.
- Slotted and Fowler flaps are more complex and are mostly seen on scale models.
Flaperons and crow braking
- Flaperons use the ailerons as flaps. Both ailerons droop together through a mix in your radio. This is useful when the plane has no dedicated flap servos.
- Crow braking on gliders lowers the flaps steeply, often 60 to 80 degrees or more, while the ailerons raise. Pilots use it for steep descents. For glider designs, see RC glider and flying wing plans.
Typical deflection
Deflection varies by model. As a rough guide, a takeoff setting is about 10 to 20 degrees and a landing setting is about 30 to 45 degrees. Past about 40 to 45 degrees, most of the extra effect is drag rather than lift.
Servo setups
- Separate servos, one per flap. The second servo is reversed in the transmitter, or mixed onto a channel.
- A reversing Y-harness, so one receiver channel drives both servos.
- One central servo driving both flaps through a torque rod.
Use servos with enough torque, and use metal gears on larger models. Mount each control horn so the pushrod hole lines up with the hinge line. For mounting details, see mounting servos in a wing.
Match both sides and set the travel
Match both flaps exactly at each setting. Uneven flaps cause a roll. Measure each side the same way, and set the travel limits so both flaps reach the same angle.
Correct the pitch change
Many models pitch up when the flaps come down, especially high-wing designs. Others pitch down. The direction depends on the design, so test it at altitude.
Correct it with an elevator-to-flap mix, which usually adds a small amount of down elevator as the flaps deploy. Set the amount by testing, not by guessing.
Radio setup
- Put the flaps on a three-position switch: up, takeoff and landing.
- Add a slow servo speed, about 1 to 2 seconds of travel, to smooth the transition.
- Deploy flaps at a speed below cruise, so the airflow doesn’t overload the servos and linkages.
Test at a safe altitude
Never test flaps for the first time low to the ground. At a safe height, slow the plane, deploy the flaps, and note three things: the pitch change, any roll, and how the stall feels. Then set the elevator mix, retract the flaps, and test again.
Common mistakes
- “Flaps are only for landing.” Small settings also shorten takeoffs.
- “More flap is always better.” Past about 40 to 45 degrees, most of the extra effect is drag.
- “Flaps always pitch the nose down.” The direction depends on the model.
- “Flaps lower stall speed with no downside.” Flaps change how the wing stalls, and an abrupt tip stall can get worse. The wing loading guide covers how loading affects stall speed.
Safety
- Never test flaps for the first time at low altitude.
- Fly the first deployment in open space with a safe margin of height.