The short answer
There is no single hardest RC plane. Pilots most often point to turbine and ducted-fan jets, scale warbirds with narrow landing gear, flying wings, and some giant-scale 3D and precision models. How hard a plane is depends on its wing loading, stability, speed and the pilot’s experience. The same plane can be easy for one pilot and hard for another.
Why there is no single answer
Four factors decide how hard a plane is to fly:
- Speed: Fast planes leave less time to react.
- Wing loading: A plane that is heavy for its wing area flies faster and lands faster.
- Stability: Planes with little natural stability need constant correction.
- Experience: A plane that feels easy after many flights can be a handful for a new pilot.
These factors interact, so a plane’s difficulty is usually specific to how it’s built and how it’s flown.
Types usually named as the hardest
Jets
Turbine jets fly at very high speeds, often 150 mph or more, and carry high wing loading. Turbine-powered models need extra training, and in the US the AMA requires a turbine waiver.
Ducted-fan (EDF) jets are small and fast, with high landing speeds. They have no propeller wash over their control surfaces, so slow-speed handling can be unforgiving.
Scale warbirds
Warbirds such as the P-51 Mustang, the Spitfire and the Corsair are often named as hard for three reasons. Their landing gear is narrow, with a taildragger layout. They have torque and P-factor effects on takeoff. And they tend to stall at the wingtip on landing. Their high wing loading also means a higher stall speed, so landings need a committed approach.
Flying wings
A flying wing has little pitch damping, so it’s sensitive to the center of gravity. Small changes in CG or control input can make it hard to keep steady.
Giant-scale 3D and precision planes
Giant-scale 3D planes have large control surfaces and little self-correction, so they respond quickly to stick inputs. Dual rates and expo make them calmer, but they don’t make the plane less demanding.
Micro planes
Small planes are not automatically easier. Micro planes can be twitchy and sensitive to wind, despite their size.
Helicopters are often called harder still than any fixed-wing plane, but they aren’t covered here.
Traits that make a plane hard
- High wing loading
- A short tail moment, with small tail surfaces
- Little or no dihedral, which means less roll stability
- An abrupt stall with little warning
- A center of gravity set near a sensitive point in its range
Gliders, by contrast, aren’t especially hard to fly.
Why small doesn’t mean easy
A smaller plane can be harder than a bigger one. A tiny, high-speed plane gives you little time to react, and a light plane can be pushed around by wind. Micro planes in particular are twitchy and wind-sensitive, so their size alone doesn’t make them a good first choice.
Stability aids and their limits
Stabilization systems such as AS3X and SAFE can make many hard types much easier to fly. They don’t replace good setup. A gyro won’t fix a badly set center of gravity or stop a tip stall, so set the CG to the manual and check it before every flight.
Working up to a harder plane
- Start with a high-wing trainer with dihedral, typically about 1 to 1.5 m span with low wing loading. These are among the easiest planes to learn on.
- Practice on a flight simulator before flying a hard type. It’s a low-risk way to learn the handling.
- Ask a club instructor to check your setup, including CG and control throws, before the first flight in a new type.
- Step up one class at a time, and treat each new type as a new plane to learn.
Precision competition is hard even on stable planes. F3A pattern aerobatics shows what that involves. For the 3D end of the scale, see RC aerobatics and 3D flying.
Safety
Jets and large gas planes carry real injury risk. Set the failsafe to throttle off, and take extra care with the first flight in any new type.