Flying Disciplines

F3P Indoor Aerobatics and Ultralight RC Planes

F3P indoor aerobatics flies ultralight foam planes in sports halls. Learn the weight limit, typical builds, and how they differ from micro park flyers.

On this page
  1. What is F3P flying?
  2. Why the planes are so light
  3. Building materials and linkages
  4. Power and weight budget
  5. Indoors versus outdoors
  6. What “ultralight” means here
  7. Safety in the hall

What is F3P flying?

F3P is the FAI class for indoor aerobatics. Pilots fly very light foam planes in sports halls, where the air is still and the space is small. The class has two sub-classes: a precision class and an aero-music freestyle class, where the flight is set to music. Speeds are close to a walk or a slow jog.

Gyros and automatic stabilization are prohibited, so the pilot does all of the flying.

Precision in F3P uses the same geometry as outdoor pattern flying, at a much smaller scale and lower speed. F3A pattern aerobatics covers the outdoor version. For the wider picture of aerobatic styles, see RC aerobatics and 3D flying.

Why the planes are so light

F3P is limited by weight. The rules set roughly 300 g ready to fly; check the current Sporting Code, since limits are updated. Most models sit well below that, usually between about 80 and 150 g, with a span of roughly 0.8 to 0.9 m.

Light weight shapes the whole build. A typical setup uses a 2S LiPo battery of roughly 250 to 350 mAh, a 10 to 20 g outrunner motor, and micro servos that weigh 3 to 5 g each. A pack gives about 5 to 8 minutes of flight, depending on the setup.

As an example, the TA Horizons TSAR Junior kit, an F3P-style plane, lists a 33 in span, a 37 in length and an all-up weight of 160 to 180 g. It has a 5 mm EPP foam fuselage with carbon-reinforced wings and mounts, and it recommends a 2S or 3S battery of 450 to 500 mAh. Specs vary by kit, but the example shows the scale this class works at.

Building materials and linkages

Most F3P planes are built from foam, usually EPP (expanded polypropylene) or 3 mm Depron sheet. Carbon rods add stiffness, and Kevlar thread is used for bracing.

Stiffness matters as much as weight. A floppy airframe flies poorly, even when it’s light. Builders usually reach for:

  • Carbon rods and reinforcements at the wing joints and suspension mounts.
  • Pull-pull or carbon pushrod linkages, which weigh less than heavier rods.
  • Minimal glue and paint, since covering and decoration add weight quickly. Foam-safe cyanoacrylate or a light contact glue is the usual choice.

Low wing loading is essential. That means light weight for the wing area.

Power and weight budget

Every gram counts. The battery, motor, servos and receiver come out of the same weight limit as the airframe. Choose the smallest battery and servos that will do the job, and weigh the whole plane before the first flight.

Indoors versus outdoors

F3P is flown indoors in sports halls. Check the hall’s rules for LiPo charging and battery storage before you book time.

Outdoors, F3P planes need calm air. Even light wind, around 5 mph, can make them hard to control. Indoor models are not good park flyers, because they’re built for still air.

What “ultralight” means here

In this class, “ultralight” means ultra-low weight. It doesn’t refer to full-size ultralight aircraft, and it isn’t the US registration threshold. In the US, models over 250 g (about 0.55 lb) need FAA registration. Most F3P models are well below that line, but check current FAA rules for your situation.

Small planes are not automatically easy, either. A plane that’s too light and floppy can fly worse than a slightly heavier one with a stiffer airframe. What makes an RC plane hard to fly covers the wider question.

Micro park flyers are a different category. Many are beginner ready-to-fly planes with stabilization, while F3P planes are precision machines with no stabilization at all.

Safety in the hall

  • Propellers can cut skin and eyes at close range. Keep spectators back, and keep your hands clear of the prop.
  • Charge LiPo batteries with care, and store them in a fireproof container.
  • Check the hall’s rules for LiPo charging and storage before you bring batteries.

The complete guide to flying disciplines

RC Aerobatics and 3D Flying: Styles, Disciplines and Planes
Read the guide

Keep exploring

Guides from other topics

All topics →