What RC glider towing is
Aerotow means a powered tug plane pulls a glider into the air on a line. It takes two pilots. The tug pilot leads, and the glider pilot follows and normally releases the line once the glider is in a safe position. The tug then drops the line over the field, away from people.
A quick note on ground tugs
Searches for “RC plane tug” often return battery-powered ground tugs that move aircraft around a hangar. Those are a different product. This article covers tow planes that pull gliders into the air.
What makes a good tug
A tug needs strong low-speed thrust. That usually means a large propeller, a high-lift wing and, often, flaps. Speed matters less than you might expect. The best tug is not the fastest plane. It’s the one that can pull the glider up steadily at a speed the glider can handle, because the tow speed has to suit the glider.
A common rule of thumb is that the tug should weigh at least as much as the glider and have power in reserve. Treat that as a guideline, not a rule, and check with experienced towing pilots at your field.
Many scale tugs copy classic full-size tow planes, such as the Piper Pawnee, the Super Cub and the Robin DR400. Some large tugs are built around 40% scale Cubs with gas engines.
Tow line and release hardware
- Line: Braided line is common, roughly 15 to 30 m (50 to 100 ft) long. Clubs vary.
- Weak link: Put a weak link in the line, rated below the strength of the airframes. It breaks first, which protects both planes.
- Visibility: Add a small drogue or streamer so the glider pilot can see the line.
- Glider release: A servo-operated hook in the nose. The glider pilot uses it to release normally.
- Tug release: A servo-operated hook on the tug, usually on top of the fuselage near the tail or behind the wing. It’s the emergency backup, which the tug pilot can use to drop the line.
Flying the tow
On takeoff, the glider sits on a dolly or wheel. A wingtip runner often helps keep it level until it lifts off.
Once airborne, the glider flies a “high tow” position, slightly above the tug and out of its prop wash. Turns should be shallow, with a bank of about 20 to 30 degrees at most, and the climb should be gentle.
Release at a safe height and position. Both pilots should agree on the calls before takeoff.
Common mistakes
- Choosing a tug with too little power for the glider. A small tug can’t safely tow a large glider.
- Assuming the fastest plane makes the best tug.
- Flying the glider below the tug, where it sits in the prop wash.
- Making tight turns on tow, which isn’t safe.
Safety calls and the drop zone
- Agree on calls before takeoff, such as “release” and “abort”, and both pilots should use them.
- If the line goes slack or the glider starts to balloon, release immediately.
- Keep the runway and the line’s drop zone clear of people.
- Make sure the tug drops the line in an empty area.
After the release
Once released, the glider needs lift to stay up. For how to find it, see RC thermal soaring. Thermal duration gliders in F3J take a different route: they’re launched on a hand-held towline rather than by a powered tug.