RC Jets

What fuel do RC jet engines use?

RC turbine jets run on Jet A-1 or kerosene mixed with turbine oil, typically 3 to 5 percent. Never use gasoline or glow fuel; check your manual.

On this page
  1. Jet A-1 and kerosene
  2. Diesel
  3. Turbine oil
  4. Mixing and storing
  5. How much fuel a jet burns
  6. Common mistakes
  7. Frequently asked
  8. Safety

RC turbine jets run on Jet A-1 or kerosene with turbine oil premixed in, usually at about 3 to 5 percent oil by volume. Gasoline and glow fuel are not used. Some engine makers approve diesel or specific kerosene grades, so check your engine’s manual before using anything other than what it names.

Jet A-1 and kerosene

Jet A-1 is the standard aviation turbine fuel. “Kerosene” is a broader term, and grades differ in additives and quality. Use only the fuel your engine maker lists. Jet A-1 and kerosene weigh about 0.8 kg per litre.

Jet A-1 is sold at many airports and some heliports. Heliports are often more willing to sell small quantities, because they’re used to fuelling small aircraft. Ask first, since policies vary.

Diesel

Some engine makers approve diesel, usually with a different oil ratio. If your maker lists it, follow their fuel spec and oil ratio exactly. If they don’t list it, don’t use it.

Turbine oil

Turbine oil is the only lubricant for the bearings, so it has to be mixed into the fuel. Mixing is measured by volume:

  • 3 percent: 30 mL of oil per litre of fuel
  • 5 percent: 50 mL of oil per litre of fuel

Use the ratio your maker specifies. Manuals often name specific turbine oils, such as Mobil Jet Oil 254 or AeroShell 500 or 560 types. Some makers offer their own blends, and some specify other oils, including certain hydraulic oils. Use only what your maker names.

A few rules apply to any oil:

  • Don’t use car oil or general two-stroke oil unless your maker names it.
  • More oil is not safer. Excess oil causes carbon build-up and smoke.
  • Don’t mix different oils. If you change oil, flush the system with fresh fuel first.

Mixing and storing

  • Mix in a clean, labelled container, away from ignition sources and hot engines.
  • Measure the oil carefully. The mix is only as good as the measurement.
  • Keep water out, and store fuel sealed and clean.
  • Filter fuel on the way in. Most turbines use an inline filter and a hopper or air-trap tank.
  • Wipe spills off the airframe before you start.

How much fuel a jet burns

As a rule of thumb, full-power burn is roughly 25 to 35 mL per minute for each kgf of thrust. A 10 kgf engine at full power burns roughly 250 to 350 mL per minute. Manufacturer figures take precedence. To turn burn rate into flight time, see RC jet flight time.

Common mistakes

  • Using glow fuel or gasoline. Those aren’t turbine fuels, and they can damage the engine or start a fire.
  • Guessing the oil ratio. Too little oil wears the bearings. Too much causes carbon and smoke.
  • Mixing oils without a flush. Some synthetic jet oils react badly with other oils.
  • Leaving old fuel in the system. Old fuel can gum up the system. Follow the maker’s storage advice.
  • Using a fuel the maker doesn’t list. A marketplace listing isn’t the same as the manufacturer’s fuel spec.

Frequently asked

Can I use diesel in an RC jet?

Only if your engine maker approves it. Some do, and they usually specify a different oil ratio. If your maker doesn’t list diesel, don’t use it.

What oil ratio should I use?

Use the ratio your engine maker specifies. Roughly 3 to 5 percent is typical for turbines, but manuals vary.

Can I use nitro fuel in a turbine?

No. Nitro (glow) fuel is for glow engines on propeller planes. A turbine needs kerosene-type fuel with turbine oil.

Safety

Keep a CO2 extinguisher at the field. Kerosene fires are hard to put out with water. Mix and refuel away from ignition sources and hot engines, and wipe up any spill before you start. For the start itself, see how to start an RC jet turbine safely. Routine fuel filter and tubing checks are covered in RC jet engine maintenance.

The complete guide to rc jets

RC Jet Engines: Turbines, EDFs and How to Get Started
Read the guide

Keep exploring

Guides from other topics

All topics →