Choosing a Plane

Electric vs Nitro RC Planes: Which Power System Should You Choose?

Electric suits most beginners. Nitro, or glow, brings a different sound and fuel routine. Here is how the two compare on cost, upkeep and safety.

On this page
  1. The short answer
  2. What “nitro” means
  3. What “electric” means
  4. Power and performance
  5. Running costs
  6. Maintenance and cleaning
  7. Noise and field rules
  8. Flight time
  9. Safety
  10. Gasoline engines
  11. Which should you choose?

The short answer

For most beginners, an electric plane is the easier choice. It starts instantly, runs quietly, needs little maintenance and is what most ready-to-fly planes use today. A nitro, or glow, engine offers a different sound and a different routine, and many experienced pilots still prefer it. Choose based on how you want to spend your time at the field.

What “nitro” means

A nitro or glow engine runs on a fuel made from methanol, nitromethane and oil. It is not gasoline. Typical airplane glow fuel contains roughly 10 to 15 percent nitromethane and about 18 to 20 percent oil. Fuel for model cars is often much richer in nitro.

Glow engines start with a glow plug. You need a small igniter, typically 1.2 to 1.5 V, to heat the plug. Once the engine is running, the heat from combustion keeps the plug lit.

Common trainer engines are .40 to .46 cubic inch two-strokes. Four-strokes, around .52 to .72 cubic inch, are quieter and turn larger propellers.

What “electric” means

An electric plane uses a brushless outrunner motor, an electronic speed controller and a lithium polymer (LiPo) battery. The system is simple. It starts with a flick of a switch, needs no fuel and has few moving parts.

Electric planes are charged between flights. Charging LiPo batteries needs care, which the safety section below covers.

Power and performance

Power is usually compared by watts per pound. Trainers need the least power for their weight, and sport and 3D planes need much more. Follow the kit manual or the motor maker’s recommendations rather than a general rule, because the right setup depends on the plane.

Electric power dominates in 3D flying and in ducted-fan jets, where instant throttle response matters. Glow engines still have their place in some sport and scale planes.

Running costs

Glow engines burn fuel, which you buy by the gallon. Electric planes use battery packs, which you buy one at a time and charge many times. A LiPo pack has a limited number of charge cycles and eventually wears out.

Running costs vary a lot with how often you fly, the fuel you buy and the batteries you choose. Work out the cost for your own flying pattern before you decide.

Maintenance and cleaning

Glow engines produce an oily residue that builds up on the airframe and the engine. You need to clean the plane after each session, and you need to tune and service the engine regularly.

Electric planes need less upkeep. The main tasks are checking the battery, the connectors and the propeller, and occasionally servicing the motor.

Noise and field rules

Glow engines are loud, and many flying fields have noise limits. Electric planes are much quieter, which is one reason many fields favor them. Check the rules at your local field before you buy.

Flight time

An electric plane usually flies for about 5 to 15 minutes on a battery pack. A glow plane usually runs for about 10 to 20 minutes on a tank of fuel. These times vary with the plane, the battery or tank size, and how hard you fly.

Safety

Each system has its own risks, and both need respect.

  • Nitro fuel. Methanol is toxic, and it burns with an almost invisible flame. Store it well away from heat, and do not breathe its fumes.
  • Running glow engines. Never reach over a running engine. Start it with an electric starter or a chicken stick, never with your fingers.
  • LiPo batteries. Charge them in a fireproof bag or container, and never overcharge or puncture them. Do not leave them charging unattended.
  • Props on any plane. Disconnect the battery or stop the engine before you handle the propeller.

Gasoline engines

Some larger planes use gasoline engines, which are spark-ignited and typically 20 cc or larger. They are a separate category, mainly used for giant-scale models. They are not a choice for a first plane.

Which should you choose?

  • Choose electric if you are a beginner, want quick sessions, or fly where noise is limited.
  • Choose glow if you enjoy engine tuning, want the sound of a running engine, and have a field where it is allowed.
  • Think about the plane first. Most ready-to-fly trainers and 3D planes are electric. Some scale and sport planes are available with either system.

For a first plane, see the best ready-to-fly RC planes for your first plane. For how plane size affects power and handling, see what size RC plane to buy first.

The complete guide to choosing a plane

The Best RC Planes for Every Skill Level and Budget
Read the guide

Keep exploring

Guides from other topics

All topics →