A typical RC turbine jet flies about 6 to 10 minutes on one tank, depending on tank size, engine and how much throttle you use. Electric ducted fan (EDF) jets usually fly about 3 to 6 minutes per battery pack.
Why the number varies
Flight time depends on three things: how much fuel is in the tank, how fast the engine burns it, and how much of that fuel you can safely use. Tank size and engine size set the first two. Your throttle habits and your reserve set the third.
The math
Use this rough formula:
Flight time = (tank size × (1 − reserve)) ÷ average fuel burn
Worked example, for illustration only:
- Tank: 2 L
- Reserve: land with 25 percent left, so 1.5 L is usable
- Full-power burn: about 300 mL per minute for a 10 kgf engine, from the rule of thumb of 25 to 35 mL per minute per kgf
- Average burn: about 60 percent of full power, or roughly 180 mL per minute
- Flight time: 1,500 mL ÷ 180 mL per minute ≈ 8 minutes
Your numbers will differ. Use your engine manual’s figures and your own logs.
Full-power burn
The rule of thumb is roughly 25 to 35 mL per minute for each kgf of thrust at full power. Manufacturer fuel figures are usually measured statically at full power, so they overstate the burn in a normal flight. For mix ratios, see what fuel RC jet engines use.
Average throttle matters
Most sport flights spend time well below full power, so the average burn is often around 50 to 70 percent of the full-power figure. Idle burn is low, often around 10 to 15 percent of full-power burn. Throttle habits change the result more than tank size does.
Typical tank sizes
- Small jets: about 1 to 2 L
- Sport jets: about 2 to 4 L
- Large scale jets: about 5 to 8 L or more
Bigger tanks add weight, and extra weight means more throttle to fly. A bigger tank doesn’t always mean a longer flight.
Reserve and alarms
- Land with reserve. A common practice is to land with about 20 to 30 percent of the fuel still in the tank.
- Use a timer and a low-fuel alarm. If your system supports it, the ECU’s fuel count and telemetry can help.
- Use a hopper tank. A hopper or air-trap tank keeps air bubbles away from the pump during manoeuvres.
- Set alarms conservatively. If the fuel count is uncertain, land early.
Running dry is not a safe plan. A flame-out on approach leaves no power for a go-around.
Weather and altitude
Hot weather and high altitude reduce thrust. They can also push the throttle up and increase fuel burn. Plan for a shorter flight on hot days or at high-altitude sites.
Compared with EDF jets
EDF jets usually fly about 3 to 6 minutes per pack, depending on battery size and throttle. A turbine’s flight is limited by its fuel, while an EDF’s is limited by its battery. Turbines are usually chosen for larger, faster jets and authentic thrust, and the longer flight time is a side benefit.
Plan the flight
- Check the fuel level before you fly.
- Plan the climb, the cruise and the approach.
- Keep your reserve for a go-around.
- Land with fuel left, and taxi at idle.
For the start and the ground checks that come before this, see how to start an RC jet turbine safely. For thrust figures that affect burn and climb, see how much thrust an RC jet engine has.