Starting a model turbine is the riskiest routine part of flying one. Preparation, a clear field and the right helper matter more than speed. The steps below are a general outline. Your engine maker’s manual and the ECU’s prompts come first, and each brand’s sequence differs a little.
Before you go to the field
- Read the manual. Know your engine’s start sequence, abort points and cool-down.
- Check the radio. Confirm the failsafe sets the throttle to idle or off, and range-check the radio.
- Charge the batteries. ECU and receiver batteries should be fully charged.
- Check the fuel. Use the approved fuel and oil mix, fill the tank, and check for water contamination.
- Check the lines. Look for leaks, cracks and air bubbles in the fuel lines, filter and hopper tank.
At the field
- Choose a clear site. Pick a spot with generous clearance behind the exhaust, and point the model into the wind. Follow the maker’s clearance figure, and give more room if you can.
- Set up a safe zone. Keep spectators, children and pets well back. Nobody should stand in line with the intake or the exhaust.
- Have a fire extinguisher ready. A CO2 extinguisher should be within arm’s reach, with a helper who knows how to use it.
- Restrain the model. Set the brakes, and use a helper or ground restraint.
- Dress for the job. Wear hearing and eye protection. Keep loose clothing, rags and fuel bottles away from the intake and exhaust.
Pre-start checks
- Intake clear of debris and foreign objects
- Throttle at the start position the ECU expects
- No fuel spills on the airframe
- Ground support unit or telemetry connected and showing sensible readings
The start sequence
The exact steps depend on your ECU, but a typical auto-start looks like this:
- Set the throttle to the start position.
- The starter spins the rotor up.
- The igniter lights, and the ECU begins feeding fuel.
- The ECU ramps the engine to idle. Watch RPM and EGT as they climb.
- A full auto-start usually takes about 30 to 60 seconds, depending on the engine.
- At idle, confirm the readings are steady. Do a brief throttle check to full, then back to idle, before you taxi.
- To shut down, reduce the throttle as the manual says, and let the ECU finish its cool-down.
Don’t cut power during the cool-down to save the battery. The cool-down protects the hot parts.
When to abort
Stop the start and follow the manual if you see any of these:
- Flames from the exhaust. A flaming start is a hot start, which is a fire risk and not normal.
- An EGT spike, or a temperature that keeps climbing without levelling off
- RPM that doesn’t climb, or that stalls
- Unusual noise, grinding or vibration
- Fuel leaks, continuing smoke or a strong fuel smell
A hot start is an over-temperature event during start-up. It’s often caused by too much fuel reaching the engine before it lights, or too little airflow. It’s one of the most serious start problems. Modern ECUs guard against it, but don’t rely on that. Don’t try to push through a hot start.
After shutdown
- Let the cool-down finish before you move the model.
- Check the engine, mounts and exhaust for leaks, loose screws and heat damage.
- Save the ECU log, and note anything unusual for the next session.
Common mistakes
- Starting downwind, which increases the risk of a hot start and exhaust fire
- Starting without a fire extinguisher at hand
- Skipping pre-start checks because it “started fine last time”
- Standing in line with the turbine wheel
- Cutting power during the cool-down
- Running a start without a helper
Related reading
- How an RC jet turbine works explains the sequence from the inside.
- RC jet engine maintenance covers post-flight checks and logging.
- What fuel RC jet engines use covers the fuel mix and storage.
- RC jet engines: turbines, EDFs and how to get started is the cluster overview.