What the tail gyro does
The tail gyro senses when the helicopter starts to yaw, which means turning around its vertical axis. It then drives the tail servo to correct the turn. In heading-hold mode, the gyro keeps the nose pointing where you set it, so you don’t have to correct the tail constantly.
Built-in or standalone gyro?
Most modern helicopters don’t use a separate tail gyro. A flybarless unit includes one, so tail setup happens in the flybarless unit’s settings (see flybarless vs flybar for the head side). Standalone tail gyros, such as the Futaba GY series, are now mostly legacy. The steps below apply to both, though the menus differ.
Set the servo type and frame rate first
Before you tune anything, set the tail servo type correctly. Servos are either standard (1,520 µs) or narrow-pulse (760 µs), and the frame rate has to match. A wrong setting can burn out the servo, so check the manual before you power up.
Mechanical setup before gain
Gain can’t fix mechanical problems, so set up the mechanics first:
- Check for binding. Look at the belt tension, bearings, pitch slider and slop in the tail.
- Center the tail servo. The servo horn should sit at 90 degrees to the pushrod when the servo is centered, and the tail slider should sit mid-travel, or where the manual says.
- Set tail limits to the maximum travel without binding.
Mounting the gyro
If you use a standalone gyro, mount it rigidly on the supplied pad, away from the motor and speed controller, with slack in the wires. Forum discussions often debate whether the gyro belongs near the tail or near the receiver. The general rule is to follow the manufacturer’s recommended location.
The mounting plate needs to be level and perpendicular to the yaw axis. Tilting it forward, back or sideways can change how the gyro reads the tail.
Direction check (motor disarmed)
Do the direction check with the motor disarmed:
- Turn the helicopter’s nose by hand.
- The tail servo must correct against the rotation.
- If it moves the same way as the turn, the gyro direction is reversed.
Set the rudder stick direction separately with the transmitter’s reverse function. A reversed gyro can spin the helicopter instantly.
Heading hold, limits and mixing
- Fly in heading hold (HH or AVCS, depending on the brand). Rate mode is mainly for setup.
- Torque precompensation is set in the flybarless unit, not with transmitter mixes.
- Revo mixing isn’t needed with a heading-hold gyro.
Tune the gain
Gain controls how strongly the gyro corrects the tail. Start at a moderate value, roughly the middle of the range, and follow your unit’s manual, because gain scaling differs between brands. Then:
- Hover and watch the tail.
- If you see fast tail wag, a quick, high-frequency oscillation, the gain is too high. Lower it in small steps, usually 3 to 5 percent at a time.
- If the tail drifts or blows out during sudden throttle changes, the gain may be too low, the headspeed may be low, or a mechanical limit may be in the way.
Keep three cautions in mind:
- Higher gain isn’t always better. Past the limit, the tail oscillates.
- Tail wag isn’t always gain. Vibration or binding can cause it, so check the mechanics first.
- Gain can’t cover mechanical slop or a slow servo.
Pirouette rate
Tune the pirouette rate and tail stop in the flybarless unit’s software. The pirouette rate sets how fast the helicopter can turn around its vertical axis. It’s often set somewhere in the 360 to 720 degrees per second range, but follow your unit’s guidance for your model.
Safety
- Do direction checks with the motor disarmed. A reversed gyro can spin the helicopter instantly.
- Keep the helicopter still at power-up until the unit finishes initializing.
- Keep the throttle hold on while you work near the rotor.
Once the tail holds steady, work through the skills progression in order.