Helicopters

RC Helicopter Autorotation: How to Practice Safe Landings

How RC helicopter autorotation works, a cautious practice progression, flare and pull timing, and when to bail out rather than force a landing.

On this page
  1. What autorotation is
  2. Why every pilot should learn it
  3. Before you practice
  4. A cautious practice progression
  5. The sequence
  6. Timing the pull
  7. Headspeed and helicopter size
  8. Bailing out
  9. Safety

What autorotation is

Autorotation is the state a helicopter enters when the motor no longer drives the rotor. The rotor keeps turning because air moves up through it during the descent. That stored rotor energy is what cushions the landing.

Many helicopters have a hold or autorotation switch that cuts the motor. How your radio and helicopter set this up varies, so check your own system.

Why every pilot should learn it

Autorotation is a core skill, not just an emergency trick. If the motor stops, the rotor can’t be powered, and an autorotation is how the helicopter gets down safely. In the skills progression, it comes after inverted hover, and it’s worth learning well before you move on to 3D. Practicing it also teaches you how the rotor behaves at lower headspeed.

Before you practice

  • Learn it on a simulator first. RealFlight, Heli-X, neXt and AccuRC are common choices.
  • Check the hold switch on the bench, with the motor disarmed. Confirm that it cuts the motor the way you expect.
  • Set the pitch from your manual. Autorotation pitch curves vary by helicopter, so use the range your manual or a trained instructor recommends. Don’t copy numbers from a forum.
  • Confirm tail behavior. Many helicopters keep the tail turning in autorotation through a one-way bearing, but check this on your own model.
  • Get a trained spotter or instructor. A club pilot can help you pick a safe site and check your setup.

A cautious practice progression

Build up in steps, and move on only when you can repeat the previous step reliably:

  1. Hover autorotations. Start low, a meter or two, over open, flat ground. Cut the motor from a hover and practice the flare and landing.
  2. Low forward autorotations. Glide into the wind from a low height.
  3. Higher entries. Once the low ones are consistent, practice from greater height.

The sequence

A typical autorotation runs like this:

  1. Hold on. Cut the motor with the hold switch.
  2. Slight negative collective. Lower the collective a little to keep headspeed up during the glide.
  3. Glide into the wind. A headwind reduces ground speed, which makes the flare easier.
  4. Flare. Use aft cyclic to slow the forward speed and the descent.
  5. Level. Bring the helicopter level.
  6. Pull collective at skid height. Apply collective just before touchdown to cushion the landing.

Pitch values depend on the helicopter, so use your manual and simulator to find the right range. The sequence is the same for most models.

Timing the pull

Timing the collective pull is the hardest part.

  • Pull too early and you waste the stored energy. The cushion works once.
  • Pull too late and the helicopter can land hard.
  • Too much negative pitch overspeeds the rotor. Too little lets headspeed bleed off. Both make the landing harder.

If headspeed falls low during the descent, bail out where your helicopter supports it, rather than forcing the landing.

Headspeed and helicopter size

Higher headspeed and heavier blades store more energy, which makes autorotations more forgiving. Larger helicopters, such as 600- and 700-class models, autorotate more easily than small ones. Small helicopters lose headspeed quickly and have less rotor inertia, so they aren’t easier to autorotate.

Bailing out

Some governor speed controllers allow a fast spool-up if the hold switch is turned off within a set window. This bailout feature varies by model and by timing. Check whether your system supports it, and don’t rely on it until you’ve practiced.

Safety

  • Practice over open, flat ground.
  • Never fly toward people, vehicles or the pit area.
  • Glide into the wind. It lowers your ground speed, which makes the flare easier to judge.
  • Practice with a spotter where possible.
  • If you’re not sure of your setup, ask a club instructor before you attempt it.

The complete guide to helicopters

Professional RC Helicopters: Choosing a Hobby-Grade Heli
Read the guide

Keep exploring

Guides from other topics

All topics →